Minoura GravityStand2 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Fahrräder Minoura GravityStand2 herunter. MINOURA GravityStand2 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
GravityStand-2
instructions manual
1
Insert Plastic Bracket into
each Leg.
Plastic
Bracket
Leg
2
Insert Metal Plate Nut
into Lower Pillar from the
bottom.
Put Plastic Cover onto each
Leg, then put through Guide
Pin into either hole for
temporally assembling.
Make sure the square holes
on the Lower Pillar face to
the front side.
Lower Pillar
Guide Pin
Plastic Cover
Metal Plate Nut
Leg
3
Screw M6x40 Bolt into the
hole without Guide Pin.
(You don't need to tighten
the bolts so much now.)
M6x40 Bolt
M6x40 Bolt
4
!
GravityStand is designed to keep
enough stability. But we highly
recommend you to x the stand
to the wall with the supplied strap
M3.5x15 or 25
Screw
to prevent any
accident.
Cradle Hook is
padded with soft
urethane to protect
your bikes finish.
Angle & position are
adjustable.
Cradle height is
adjustable in 3
positions without
requiring any tools.
Set up is very easy.
Just lean to the wall.
(Pillar should be set
parallel to the wall)
Remove Guide Pin.
Remove
5
Screw M6x40 Bolt to
another hole.
M6x40 Bolt
M6x40 Bolt
6
Tighten all M6x40 Bolts
firmly.
7
Install Metal Plate Nut to
the top holes on Lower Pillar
with M6x12 Bolt.
Metal
Plate
Nut
M6x12 Bolt
- 1 -
(ver.1.3 2014/8)
Required Tool: 1 x M5 Hex Wrench
(included)
<Assembled Image>
Guide Pin
!
Hook pad may leave
a mark on the frame.
Consider wrapping
the hook with bar
tape to avoid any
staining.
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - GravityStand-2

GravityStand-2 instructions manual1Insert Plastic Bracket into each Leg.PlasticBracketLeg2Insert Metal Plate Nut into Lower Pillar from the bottom.Put

Seite 2 - FOR MORE INFORMATION

- 2 -8Join Upper Pillar with the installed metal plate nuts. Make sure the square holes on Upper Pillar align correctly.Tighten the M6x12 bolts firmly

Kommentare zu diesen Handbüchern

Keine Kommentare