Minoura BikePit3 Bedienungsanleitung PDF herunterladen

(Ver.3.3 2015/4)

- 1 -

bicycle storage stand

BikePit3

instructions manual

Thank you for choosing Minoura

BikePit

BikePit is a very convenient and easy-to-setup bike

storage stand that can be installed in the room

which ceiling height is between 1.7 and 3.1 meters.

BikePit comes with 2 sets of bike hanging hooks.

The bike will be hung down front the front wheel in

order to save storage space most efficiently.

You can add some more accessories by adding

optional attachment.

Read this instructions manual carefully before use

for your safety, and keep in hand for future reference.

Part Name

Upper Rubber Cup

(with spring inside)

Top Pillar

(40mm diameter)

Clamp on Upper Pillar

(with Plastic Shim)

Front Wheel Hook

Bottom Pillar

(45mm diameter)

Clamp on Lower Pillar

(without Plastic Shim)

Rear Wheel Suppport

Lower Rubber Cup

Important Notes

• Keep the recommended tightening torque

(5 – 8 N.m) on every bolt.

• It's your duty to hold the top pillar to the ceiling

or wall by using the supplied plastic tie in order

to avoid falling down accident.

Minoura will not be responsible to any accident

caused by not using this plastic tie.

• For standard 2 wheel bike only. Not for use with

tandem bike, long wheel base bike or the bike

heavier than 25 kgs.

• Max load is totally 50 kgs. However, please be

aware that hanging on only one side is not good

for keeping balance and it may cause falling

down problem.

So the load shall be limited by 20 kgs (5 kgs less)

when using just one side.

• The pillar is supported by the internal spring

applying pressure to the ceiling.

Make sure that the pillar comes in contact with

a stud or other reinforced area of the ceiling

otherwise the pressure may cause the break

through dry wall or other non- supportive

material.

• Adjust the pillar length correctly.

If the red indicator appears in the upper rubber

cup even after setting up, it's the evidence the

pillar is not adjusted properly (too short).

Remove the pillar and extend slightly more.

• Do not use the pillar upside down. The larger

diameter pillar must be on the bottom.

Do not use the pillar horizontally.

• The ceiling and oor must be parallel and level. If

not, it cannot hold BikePit safely.

• The pillar must not be set at any angle.

If the pillar has been slanted, the pillar may

become loose and fall.

• The rubber cup material may leave a mark on

some ceilings and/or oor. We recommend

placing a small piece of fabric or paper between

the rubber cup and the ceiling.

• The pillar will turn together with bikes if it's

caught when you passing by. Keep away any

fragile items from the BikePit setting area.

Red Indicator

(in the upper cup)

Pillar Joint

Recommened Tightening

Torque: 5 – 8 N.m

1 2 3 4

Inhaltsverzeichnis

Seite 1 - BikePit3

(Ver.3.3 2015/4)- 1 -bicycle storage stand BikePit3 instructions manualThank you for choosing Minoura BikePit.BikePit is a very convenient and easy-

Seite 2 - How To Install Hooks

- 2 -12Front Wheel Hook should be installed alternately to avoid conflicting the handlebar.Both hooks must be set at completely opposite side. Narrowe

Seite 3 - How To Re-Install Clamp Band

- 3 -Rear Wheel Support will be installed on the Bottom Pillar so it doesn't need the plastsic shim.The bike just being hung from top hook will n

Seite 4 - Front Wheel Hook

ContactMINOURA North America(for U.S. residents only)Hayward, Califormia, U.S.A.Phone 1-510-538-8599 / Fax [email protected]

Kommentare zu diesen Handbüchern

Keine Kommentare

Minoura BikePit3 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Fahrräder Minoura BikePit3 herunter. MINOURA BikePit3 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Fahrräder Minoura BikePit3