Minoura BikeTower10 Bedienungsanleitung PDF herunterladen

bicycle storage stand

BikeTower10

instructions manual

(ver.1.4 2015/4)

Upper Rubber Cup

(with spring inside)

Top Pillar

(40mm diameter)

Bike Cradle

Pillar Joint

Recommened Tightening

Torque: 5 – 8 N.m

Bottom Pillar

(45mm diameter)

Arm

Lower Rubber Cup

(without spring inside)

Cradle Hook

(universal on both sides)

Clamp on Upper Pillar

(with Plastic Shim)

Clamp on Lower Pillar

(without Plastic Shim)

｝

Thank you for choosing Minoura

BikeTower10

BikeTower10 is a very convenient and easy-to-setup bike

storage stand that can be installed in the room which

ceiling height is between 1.7 and 3.1 meters.

BikeTower10 comes with two bike cradles, and it can

be expanded up to 4 bikes and other items by installing

optional bike cradles and attachments.

Read this instructions manual carefully before use for

your safety, and keep in hand for future reference.

Part Name

Important Notes

• For standard 2 wheel bike only. Not for use with

tandems or long wheel base bicycles.

• Each bke cradle is rated to hold 25 kgs.

If mounting heavy bikes, check the bolts often to

make sure they are not loose.

• The pillar is supported by the internal spring

applying pressure to the ceiling.

Make sure that the pillar comes in contact with

a stud or other reinforced area of the ceiling

otherwise the pressure may cause the break

through dry wall or other non supportive

material.

• Adjust the pillar length correctly. If the red plastic

appears in the upper rubber cup, the pillar is

not adjusted properly (too short). Remove the

BikeTower and and extend the pillar slightly

more.

• Do not use BikeTower upside down. The larger

diameter pillar must be on the bottom.

NEVER use BikeTower horizontally. It is for

vertical use ONLY.

• The ceiling and oor must be parallel and level.

If not, it cannot hold BikeTower safely.

• The pillar must not be set at any angled.

If the pillar has been slanted, BikeTower may

become loose and fall.

• The rubber cup material may leave a mark on

some ceilings and/or oor. We recommend

placing a small piece of fabric or paper between

the rubber cup and the ceiling. Do not use slippy

Vinyl sheet.

• The hook material may stain on your bike frame,

especially in light color such as white, depending

on the top nish condition.

We recommend placing a piece of bar-tape

between the hook and the frame or wrapping

the hook with bandage in order to avoid direct

touching each other.

• The clamps for installing the bike cradles are

pre-installed on the pillar and you don't need

to remove it basically. However, if you need

to disassemble and install the clamp onto the

pillar again, carefully follow the instructions

described in page 4. Wrong clamp direction will

cause serious problem that the clamp cannot

hold the pillar properly and the bike will slide off

suddenly. It's really dangerous.

Warranty Period

Minoura offers

1-year limited warranty

to this product

from the date of your purchase.

Any natural wear and the problems caused by miuse

or unapproved modification will not be covered by this

program.

For more details, read the enclosed

Minorua Limited

Warranty Policy

card in the kit.

Also please regularly check our Minoura web site for the

latest information.

• Keep the recommended tightening torque

(5 – 8 N.m) on every bolt.

• It's your duty to hold the top pillar to the ceiling

or wall by using the supplied plastic tie in order

to avoid falling down accident.

Minoura will not be responsible to any accident

caused by not using this plastic tie.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - BikeTower10

bicycle storage stand BikeTower10 instructions manual(ver.1.4 2015/4)Upper Rubber Cup(with spring inside)Top Pillar(40mm diameter)Bike CradlePillar J

Seite 2 - Schematics of Cradle

- 2 -How To Set Up Pillar1241) Extend pillar, 2) Adjust pillar length, then 3) Install in room.Loosen the upper bolt, extend Top Pillar, attach to bot

Seite 3 - How To Install Bike Cradle

- 3 -123How To Install Bike CradleBike Cradle is pre-installed on each pillar and the clamp band is temporally tightened.Change the clamp position !To

Seite 4 - How To Re-Install Clamp Band

- 4 -How To Mount Your BikeTo mount your bike on BikeTower, place the hooks under the crossing sections of the frame tubing.Normally, you will hook th

Kommentare zu diesen Handbüchern

Keine Kommentare

Minoura BikeTower10 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Fahrräder Minoura BikeTower10 herunter. MINOURA BikeTower10 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Fahrräder Minoura BikeTower10